Horoskop forum

My washing machine fills with water normally, but then it just stops and never starts the spin or wash cycle. No error codes appear, just silence after filling. I already tried restarting it, but the same thing keeps happening every time.

A situation like this usually means the machine is stuck at the transition stage between filling and starting the motor cycle. Common reasons are a faulty lid/door switch, a worn drive belt, or a control board not sending the start signal. Since water intake works, the issue is deeper in the cycle system, not plumbing. I wouldn’t keep forcing it to run. I’ve seen similar cases where a technician from Appliance Repair in Florida fixed it on the first visit after replacing a small sensor instead of major parts.